Home > Products > Vertical machining center > MT-1370V/VS
Products
Vertical machining center
 
Features
1.Pneumatic counterweight system greatly lessens the ripple effect of inertia during the feed motion on Z axis.
2.Base frame consist of four heavy duty roller linear guides, greatly strengthened the fundamental structure of machine.
3.Y axis used twin-chip auger (front-out)
Standrd Accessories
1. Full-closed splash guard 2. Automatic power off
3. Oil skimmer system 4. Water gun and air gun
5. Chips flush coolant system 6. Tools box
7. Work lamp 8. Arm type ATC with 24 tool capacity
9. Automatic lubrication system 10. Heat exchanger
11. Alarm light 12. Screw type chip conveyer
13. Automatic tool length measuring device 14. Spindle oil cooler system
15. Spindle speed 10000rpm 16.MITSUBISHI controller FCA70P
Optional Accessories
1.FANUC system controller 2.SIEMENS system controller
3.Direct type Spindle 12,000/15,000 RPM 4.Built type Spindle 20,000/24,000 RPM
5.Coolant through spindle 6.Air conditioner
7.Transformer 8.Voltage regulator
9.Flat type chip conveyer 10.CE mark
11.3-Axes optical scale 12.Breakage detection system
13.Oil mist collector 14.Inverter ATC System
 
Specification
Model MT-1370 V MT-1370 VS
Table Size mm 1400x600 1400x600
T-slot (width x no x distance) mm x T 18 x 5 x110 18 x 5 x110
Maximun table load kgs 800 800
Travel X, Y, Z -axis mm 1300x650x670 1300x680x690
Table top surface to spindle nose mm 120-790 105-805
Distance between spindle center and column surface mm 670 690
Linear guideway type ( X / Y / Z-axis ) mm 35 / 45 / 45 35/35,45/45 (Roller type)
Ball screw (X/ Y/ Z-axis)   ∅40 / ∅40 / ∅40 ∅40 / ∅40 / ∅40
Spindle Spindle holder   BELT DIRECT
Taper   BT40 BT40
Diameter mm 60 70
Spindle speed rpm 10000 10000
Feed Cutting feedrate X/ Y/ Z (G01) m / min 20 / 20 / 20 20 / 20 / 20
Rapid feedrate X/ Y/ Z (G0) m / min 36 / 36 / 36 30 / 30 / 30
ATC Tool selection   ARM ARM
Max. tool Dia mm ψ75 /ψ150 ψ75 /ψ150
Max. tool length mm 300 300
Max. tool weight kgs 7 7
Tool type   BT40 BT40
Tool magazine capacity (Arm type) T 24 24
Motors Spindle motor (30 min. ) kw 11 / 15 11 / 15
X/ Y/ Z -Axis kw 3.0/3.0/4.0 (Mitsubishi)
3.0/3.0/4.0 (FANUC)
3.0/3.0/4.0 (Mitsubishi)
3.0/3.0/4.0 (FANUC)
Coolant pump kw 0.75 0.75
Other Machine Space ( L x W ) mm 3300x2250 3300x2250
Coolant tank capacity L 350 350
Net weight kgs 8000 8000
* All specification , dimension and design characteristics shown in this catalogue are subject to change without notice.